MiniMeP10 & P12ModelsEarthquake Sound Corporationwww.earthquakesound.comSound That Will Move YouUser's Manual
System ConfigurationsThe following pages show some typical connections that you might make in your installation. They show how the inputs and outputs
Connections to a pre-amplifier using “Y” cablesIf your pre-amplifier does not have a sub/LFE output, you can use “Y” cables to send its main outputs t
Earthquake Sound, 2727 McCone Avenue, Hayward, CA 94545 USAwww.earthquakesound.comVOLUMEFREQUENCYMODEPHASEAUTOMIN50HzMAXRIGHTPOWERLEFT160HzSUB0OFFLFE1
AUTOOFF ONVOLUMEFREQUENCYMODEPHASEMIN50HzMAX160HzSUB0LFE180Adjusting the controlsThere are two main methods for adjusting the level, crossover frequen
MiniMe P10 Specifications MiniMe P12 SpecificationsAmplifier Output Amplifier Output600 Watts (4-Ohm impedance) 600 Watts RMS (4-Ohm impedance)High Cu
Limited 5-Year WarrantyEarthquake warrants the original purchaser that all Factory Sealed New Audio Products to be free from defects in material and w
Earthquake Sound Corporation2727 Mc Cone Avenue,Hayward, California 94545Ph (510) 732-1000Fax (510) 732-1095www.earthquakesound.com
Safety Instructions13. Damage Requiring Service — The Component 1. Read Instructions — All the safety and operation should be served only by EQ qualif
WARNING: The MiniMe subwoofers are capable of generating high sound pressure levels. You should exercise caution when operating these
IntroductionPlease take a moment to fill out and mail the Earthquake Warranty Registration card. Also read the serial number located on the control pa
(1) Line Level RCA Inputs terminals will accept up to 16-gauge quality speaker Connect with RCA type patch cords to the line level wire. The Inputs s
(6) Auto ON/OFF (10) Sub Operation SwitchWhen the main “POWER” ON/OFF switch is in the In LFE position, the Frequency adjustment becomes “OFF” positi
• Do not let anything come into contact with the panel Installationand keep at least two inches away from any walls. Observe the following g
AC outlets on the same circuit breakerPower stripTape DeckDVDPre-amplifierAmplifierSubwooferConnections• This diagram shows all the low power compone
MiniMe1P= Passive Radiator A= Active DriverMiniMe2PAMiniMe3PALocationFact: Subwoofers reproduce frequencies with #1 is very good positioning.w
Comments to this Manuals