Earthquake W1265V User Manual Page 25

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 24
Operator's Manual
Trail Warrior Quick Split 12-Ton Log Splitters
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 25
Model 2006/42/EC
Operator Ear
L
pa
(dBA)
2006/42/EC
Sound Power Level
L
wA
(dBA)
W1265BCE
Log Splitter
89 104
SOUND AND VIBRATION LEVELS
Sound levels tested in accordance with ISO3744 and ISO11201 - Grade 2 (Engineering)
Method. Readings taken with engine at full throttle.
EAV: Exposure Action Value; ELV = Exposure Limit Value.
OPERATING THE SPLITTER EUROPEAN MODELS:
1. Set up the log splitter on a clear, level area and block the
wheels.
2. Place a log on the beam against the wedge. Make sure that
the log is placed securely on the wedge and against the beam.
3. While holding the Flow Control valve lever (rear lever) in the
rearward position with one hand, use the other hand to push
the Direction Control valve lever (front lever) in the forward
(splitting) direction so that the cylinder will drive the log into
the wedge. Extend the cylinder until the log splits or until the
cylinder travels to the end of its stroke. If the log has not com-
pletely split after the cylinder has reached the end of its stroke,
retract the cylinder by pulling the Direction Control valve lever
(front lever) in the rearward (return) direction. The Flow Control
valve lever (rear lever) must always be held in the rearward
position in order for the Direction Control valve to function.
IMPORTANT: LEAVING THE VALVE IN THE ACTUATE”
POSITION AT THE END OF THE STROKE MAY DAMAGE
THE PUMP. ALWAYS USE EXTRA CARE WHEN SPLITTING
LOGS WITH ENDS NOT SQUARE.
NOTE: If a spark arrestor is not included with the engine,
obtain a spark arrestor for the exhaust system from the
manufacturer of your engine before operation in wooded
areas. See also the "Warning and Safety Precautions" sec-
tion of this manual.
REMOVING A LOG AFTER A JAM
1. Pull back controls so that the log pusher is fully retracted.
2. Insert a triangular wedge of wood under the log and activate
the log pusher to push the wedge under the jammed log.
3. Repeat this process using progressively large wedges until
the jammed log is free.
WARNING
NEVER HAMMER ON THE JAMMED LOG OR PLACE
YOUR HANDS NEAR THE LOG WHEN ATTEMPTING TO
FREE IT.
IMPORTANT
TO EXTEND THE LIFE OF THE HYDRAULIC CYLINDER,
AVOID BOTTOMING OUT” WEDGE PLATE TO THE FOOT
PIECE. TO CONFORM WITH INDUSTRY SAFETY RECOM
MENDATIONS, THE WEDGE STOPS TWO INCHES FROM
THE END OF THE STROKE.
Model 2006/42/EC
Operator Ear
L
pa
(dBA)
2006/42/EC
Sound Power Level
L
wA
(dBA)
W1265VCE
Log Splitter
84 93.5
Page view 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Comments to this Manuals

No comments