Earthquake 10310 User Manual download pdf (Page 13)

Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 CST 13

Operator's Manual

Dually™ Earth Auger Powerhead

COOLING FINS

Cooling ns, air inlets and linkages must be free from any debris

before each use.

AIR FILTER

Never run engine without air cleaner properly installed. Added

wear and engine failure may occur if air cleaner is not installed

on engine.

Service air cleaner every 3 months or after 20 hours of operation.

Clean lter daily in extremely dusty conditions.

STEPS FOR CLEANING BLOCK STYLE FOAM AIR FILTER

1. Before removing the air lter cover, move the choke lever to

the choke position. SEE FIGURE 2.

2. To remove air lter cover, squeeze the latch tabs on both sides

of the cover. SEE FIGURE 3.

3. Once the latch tabs are released, remove the air lter cover

by rotating the cover away from the engine. SEE FIGURE 4.

4. Remove the foam lter element (SEE FIGURE 5) and replace

with a new oiled lter, or clean the original foam lter with

warm water and mild soap by following the previous steps for

Cleaning Air Filter. Remember to thoroughly oil the foam lter

with 30 or 40 weight motor oil and squeeze out any excess

oil.

5. Reinstall the foam lter, pressing it in place to ensure that the

foam is fully seated into its sealed position. SEE FIGURE 6.

6. Replace the air lter cover so that it fully snaps into place and

is secured by the latch tabs. Check that the cover is securely

attached by pulling slightly on the cover. If the cover doesn’t

move when pulled, it is secure.

Figure 2

Figure 3

Figure 4 Figure 5

Figure 6

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 71 72

No comments

Earthquake 10310 User Manual Page 13