Earthquake WP4310 User Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
EARTHQUAKE, Division of Ardisam, Inc.
ARDISAM
.com
.com
Page 12
800-345-6007
TROUBLESHOOTROUBLESHOO
TROUBLESHOOTROUBLESHOO
TROUBLESHOO
TINGTING
TINGTING
TING
Problem Possible cause Remedy/Action
Engine will not start
Engine runs rough, floods during
operation
Engine is hard to start
Engine misses or lacks power
Engine runs, but has no power
Engine revs too high
Engine runs, but doesn’t pump
water
1. Flip switch to on position
2. Connect spark plug wire to spark plug
3. Clean or replace spark plug
1. Clean or replace air cleaner
2. Turn off choke
3. Call factory
1. Drain old fuel and replace with fresh.
Use gas stabilizer at end of season
2. Make sure spark wire is securely
attached to spark plug
3. Clean carburetor, use gas stabilizer,
new gas can
1. Remove and clean
2. Clean or replace
3. Call factory
4. Replace spark plug and adjust gap
1. Turn off choke after engine is running
2. Call factory
3. Call factory
1. Add fuel to tank
1. Prime water pump as directed in
manual
2. Lower suction hose
3. Unclog foreign objects from strainer
4. Replace hoses
1. Power switch off
2. Spark plug wire disconnected
3. Spark plug has no spark
1. Dirty air cleaner
2. Choke partially engaged
3. Carburetor out of adjustment
1. Stale fuel
2. Spark plug wire loose
3. Dirty carburetor
1. Clogged fuel tank
2. Clogged air cleaner
3. Improper carburetor adjustment
4. Spark plug dirty, improper gap, or
wrong type
1. Choke on
2. Carburetor out of adjustment
3. Worn engine lower seal
1. Low fuel in tank
1. Pump not primed
2. Suction hose elevated too high
3. Strainer clogged
4. Hose(s) damaged
SERVICESERVICE
SERVICESERVICE
SERVICE
, TROUBLESHOO, TROUBLESHOO
, TROUBLESHOO, TROUBLESHOO
, TROUBLESHOO
TING AND REPTING AND REP
TING AND REPTING AND REP
TING AND REP
AIRAIR
AIRAIR
AIR
CAUTION
Practice safety at all times. Engine must be turned
off and allowed to cool, and spark plug wire must
be disconnected before attempting any
maintenance or repair.
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments