Earthquake WP4310 User Manual download pdf (Page 7)

ARDISAM

.com

Page 7

800-345-6007

EARTHQUAKE, Division of Ardisam, Inc.

MIXING FUEL AND FILLING FUEL TANKMIXING FUEL AND FILLING FUEL TANK

MIXING FUEL AND FILLING FUEL TANK

Mixing Fuel

1. Fuel must be mixed in a container outside in a well

ventilated area.

2. Fill certified fuel container 1/4 full of recommended

fuel.

3. Add recommended amount of 2-cycle oil. DO NOT

use 2-cycle marine oil.

4. Screw on container cap straight and tight.

5. Shake the container to mix fuel and oil.

6. Unscrew cap slowly to vent. Add the remainder of fuel

requirements.

7. Wipe away any spilled fuel or oil and allow to

evaporate before moving or transporting.

CAUTION

Avoid injury! Never store engine with fuel in the

tank indoors. Fuel and fuel vapors are highly

flammable.

CAUTION

Avoid injury! Never mix fuel and oil directly in

engine fuel tank. Use only nonmetal, portable fuel

containers approved by the Underwriter’s

Laboratory (U.L.) or the American Society for

Testing & Materials (ASTM).

CAUTION

Avoid injury! An adult must always handle and fill

the engine with fuel.

CAUTION

Avoid injury! Always handle gas in a well ventilated

area, outdoors, away from flames or sparks.

This engine uses a gas/oil mixture. DO NOT run on

straight gas only, engine damage will result.

Filling Fuel Tank

1. Shut-off engine and allow engine to completely cool

before refilling the fuel tank.

2. Move to a well ventilated area or outdoors away from

flames and sparks.

3. Clean debris from area around the fuel cap.

4. Loosen fuel cap slowly. Place the cap on a clean, dry

surface.

5. Carefully add fuel without spilling.

6. Do not fill gas tank completely full allowing space for

fuel to expand.

7. Immediately replace fuel cap and tighten. Wipe off

spilled fuel and allow to dry before starting engine.

ASSEMBLASSEMBL

ASSEMBL

1. Connect the suction hose to water pump inlet and the

discharge hose to pump outlet using provided hose

clamps.

2. Attach suction screen to inlet hose.

NOTE: 1” suction hose is required.

NORMAL OPERANORMAL OPERA

NORMAL OPERA

TIONTION

TION

1. Always prime water pump fully with water before

starting engine. Loosen the filler cap and fill the pump

with priming water.

CAUTION

Avoid injury! DO NOT start engine if fuel is spilled.

Wipe off excess fuel and allow to dry. Remove

engine from area to avoid sparks.

OPERAOPERA

OPERA

TIONTION

TION

Fill Port

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

Earthquake WP4310 User Manual Page 7

Comments to this Manuals

Related products and manuals for Pumps Earthquake WP4310