Earthquake 9060300 User Manual download pdf (Page 9)

Operator’s Manual

Viper® 196cc 4-Cycle Engine

Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 9

CHECKING AND ADDING OIL

Be sure the engine is located on a level surface before checking

or relling oil.

1. Clean around oil ll area and drain plug. SEE FIGURE 1.

2. Slide out dipstick and wipe clean with cloth. SEE FIGURE 1.

3. Reinsert and tighten dipstick.

4. Slide out dipstick and check oil.

5. If oil level is below the top thread of the oil ll hole, rell to

upper level. SEE FIGURE 1.

6. Change oil if contaminated.

Viper® engine oil may be put in through the oil dipstick hole or

through the oil ll plug opening. If an oil plug is present, loosen

screw and ll oil until oil level is even with top thread in plug hole.

CHECKING AND FILLING FUEL TANK

Be sure the engine is located on a level surface before checking

or refilling fuel. Use unleaded regular, unleaded premium

automotive fuels only. Commercial fuel may contain up to

10% ethanol. Ethanol additives to fuel are known to cause

deterioration of fuel lines and other fuel components. Viper®

recommends the addition of fuel stabilizer to protect your

engine’s fuel system and prolong the life of your engine. DO

NOT mix oil with fuel.

1. Make sure engine is cool and not running while lling.

2. Remove fuel cap.

3. Fill tank to fuel level limit. SEE FIGURE 2.

Note: Do not overll.

3. Replace cap and remove any spilled fuel before operating.

WARNING

FUEL IS HIGHLY FLAMMABLE AND MUST BE HANDLED

WITH CARE. NEVER FILL THE TANK WHEN THE ENGINE

IS HOT OR RUNNING. ALWAYS MOVE OUTDOORS TO

FILL THE TANK.

upper level

lower level

Figure 1

oil ll area/

dipstick

oil drain

plug

Figure 2

SECTION A-A

SCALE 1 : 5

DETAIL B

SCALE 1 : 3

PARTS TO BE FREE OF

BURRS AND SHARP EDGES

THIS DRAWING AND ALL INFORMATION CONTAINED HEREIN IS AND REMAINS THE PROPERTY OF ARDISAM INC.

AND IS CONFIDENTIAL. IT IS SUBMITTED AND MAY BE USED ONLY IN CONNECTION WITH

ARDISAMS' PROPOSALS

AND/OR ITS CUSTOMERS' ORDERS. IT SHALL NOT BE DISCLOSED TO OTHERS OR COPIED

WITHOUT ARDISAMS'

SPECIFIC WRITTEN CONSENT AND SHALL BE IMMEDIATELY RETURNED UPON REQUEST.

MATERIAL

NAME

TREATMENT

DR BY

APPD PRT NO

92000

PT WEIGHT

SURFACE AREA

DATE

REVISION

THIRD ANGLE PROJECTION

SEE BILL OF MATERIALS

NONE

8153

1776531

ENGINE 196CC XINGYUE

HORIZ THREADED M16X1.5

LAR

RJR 8/22/11

7/28/2011

SHEET: 1 OF 1

ALL ANGLES ARE DECIMAL DEGREES

UNLESS OTHERWISE SPECIFIED

DIMENSIONS ARE IN MILLIMETERS

THREADS CLASS 2

0.0 ± 1.0°

0 ± 2°

ANGLES:

0.000 ± 0.250 MM

0.00 ± 0.75 MM

0.0 ± 2.5 MM

OTHERWISE NOTED:

TOLERANCE UNLESS

fuel level limit

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments

Earthquake 9060300 User Manual Page 9

Comments to this Manuals

Related products and manuals for Special machinery Earthquake 9060300