Earthquake 6015V User Manual download pdf (Page 17)

17Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5

Operator’s Manual

6015 Series CRT Rototiller

DEPTH REGULATOR LEVER

Tilling depth is controlled by the height of the depth regulator lever.

To adjust tilling depth. SEE FIGURE 8

1. Remove detent pin.

2. Raise the depth regulator lever to position tines at chosen

tilling depth.

3. Align hole in depth regulator lever with hole in depth regulator

bracket and insert detent pin.

Depth Regulator Lever Down = Shallower tilling. Place the

detent pin in the top hole of the depth regulator lever for

shallowest tilling.

Depth Regulator Lever Up = Deeper tilling. Place the detent

pin in the bottom hole of the depth regulator lever for

deepest tilling.

depth regulator

bracket

depth regulator

lever

detent pin

FIGURE 8

drive safety control lever disengaged (NEUTRAL)

forward cable

upper jam nut

lower jam nut

FIGURE 9

WARNING

DO NOT ADJUST TILLING DEPTH UNLESS DRIVE

SAFETY CONTROL LEVER IS RELEASED TO NEUTRAL

POSITION.

ALWAYS SET THE DEPTH REGULATOR LEVER IN THE

TRANSPORT POSITION BEFORE STARTING ENGINE,

THAT IS, PLACE THE DETENT PIN IN THE HIGHEST HOLE

OF THE DEPTH REGULATOR LEVER.

tension nut

spring

BELT TENSION ADJUSTMENT

Proper belt tension is critical to good performance. After 1/2 hour

of operation, all cables may have to be adjusted due to initial

stretch. Thereafter, check tension after every 2 hours of operation.

Proper tension is achieved when the spring compresses 1/4”

when drive lever is engaged.

To increase belt tension:

1. Loosen upper jam nut. SEE FIGURE 9

2. Tighten the lower jam nut in 1/8” increments, making sure not

to over adjust the tension.

3. Check adjustment by measuring spring compression when

drive lever is engaged. (Proper spring compression 1/4”)

4. When proper adjustment is achieved, tighten upper jam nut.

This procedure can be repeated until conduit adjustment bolts

are fully adjusted. If no more adjustment can be made, belt may

need to be replaced.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Comments to this Manuals

No comments

Earthquake 6015V User Manual Page 17

Comments to this Manuals

Related products and manuals for Special machinery Earthquake 6015V