Earthquake 6015V User Manual download pdf (Page 9)

9Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5

Operator’s Manual

6015 Series CRT Rototiller

CAUTION

DO NOT TRY TO LIFT THE ROTOTILLER FROM THE

CARTON.

DO NOT ADD ENGINE OIL INTO GEAR CASE DIPSTICK

HOLE.

ASSEMBLY

Your rototiller comes fully assembled except for a few parts.

The following instructions will help you unpack your tiller and

assemble and adjust your tiller’s depth regulator lever, cable

tension and handle bar height. You will need 2- 9/16” wrenches.

Carton Contents

Rear Tine Rototiller w/Handle Bar

2 - Side Shields

2 - Wheels

Depth Regulator

Parts Bag

Tools Required for Assembly

2 - 9/16” wrenches

UNPACK

1. Open top of carton and remove handle bar assembly.

2. Find parts packet. Parts packet contains:

4 - 3/8-16 x 1-3/4” hex head bolts

2 - 3/8-16 x 1” hex head bolts

6 - 3/8-16 nylock nuts

6 - 3/8” at washers

6 - 1/4-20 x 3/4” hex head bolts

6 - 1/4-20 nylock nuts

1 - detent pin

12 - 1/4” at washers

2 - Handle bar extensions

CE parts packet also contains:

2 - 3/8-16 x 1” hex head bolts

2 - 3/8-16 nylock nuts

2 - 3/8” at washers

NOTE: Parts packet also includes Engine Manual, Warranty

Registration Card and this Operator’s Manual.

3. Cut open seams of carton, exposing all contents and remove

machine by:

a. Attaching loose wheels in box onto machine with wheel

lock pins in free-wheel position. Slide wheel all the way

onto the axle and insert lock pin through the axle hole

only. (SEE OPERATION SECTION)

b. Roll tiller from carton.

IMPORTANT

THE RIGHT AND LEFT SIDES OF YOUR

ROTOTILLER ARE DETERMINED FROM

THE OPERATING POSITION AS YOU FACE

THE DIRECTION OF FORWARD TRAVEL.

ENGINE IS SHIPPED FROM FACTORY

WITHOUT OIL. YOU MUST ADD ENGINE

OIL BEFORE STARTING ENGINE.

TILLER TRANSMISSION IS SHIPPED FROM

FACTORY WITH THE PROPER AMOUNT

OF GEAR LUBE.

detent pin

depth regulator

adjusting knob

FIGURE 1

INSTALL DEPTH REGULATOR

1. Locate depth regulator and detent pin. SEE FIGURE 1

2. Unscrew adjusting knob from the top of the depth regulator

and slide depth regulator up into vertical slot at the rear of the

tine shield. SEE FIGURE 1

3. Reattach the adjusting knob to the top hole of the depth

regulator.

4. Insert detent pin through the hole in the vertical slot and a

hole in the depth regulator to hold it in place.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Comments to this Manuals

No comments

Earthquake 6015V User Manual Page 9

Comments to this Manuals

Related products and manuals for Special machinery Earthquake 6015V