Earthquake 6015V User Manual download pdf (Page 14)

Operator’s Manual

6015 Series CRT Rototiller

14 Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5

STARTUP

The controls required to start and run the rototiller are located

on the engine and are the choke and throttle levers. The choke

lever is marked on one end with CHOKE and on the other with

RUN. The throttle lever is marked on one end with a STOP icon

and on the other with a FAST icon. There is also a SLOW icon

next to STOP to indicate a low throttle position.

NOTE: The 6015V does not have the stop function on the

throttle lever and instead has an ON/OFF switch located near

the recoil start.

A more detailed description of engine operation and all related

precautions and procedures can be found in the engine

manufacturer’s manual that accompanies each tiller.

COLD STARTS

1. Turn ON/OFF switch to the ON position, if equipped.

2. Move choke lever to CHOKE position.

3. Move throttle lever to half way between SLOW and FAST.

4. Pull starting rope out slowly one time and allow to return

normally.

5. Pull starting rope out rapidly, and allow rope to return

normally.

6. When engine starts, gradually move choke lever to RUN

position and move throttle lever to FAST position for tilling.

RESTARTING A WARM ENGINE

Restarting an engine that is already warm from previous running

does not normally require use of the choke.

1. Move throttle lever to half way between SLOW and FAST.

2. Pull starting rope out rapidly, and allow rope to return

normally. Repeat until engine starts.

3. Adjust throttle speed to FAST position for tilling.

STOP

DANGER

ALWAYS KEEP HANDS AND FEET CLEAR OF ROTATING

MACHINE PARTS.

SLOW FAST

IMPORTANT

IDLE SPEED

Use the SLOW position or a position between SLOW and FAST

on the throttle lever to reduce stress on the engine when tilling

is not being performed. Lowering the engine speed to “idle” will

help extend the life of the motor, as well as conserve fuel and

reduce the noise level of the equipment.

OPERATING SPEED

For tilling, set the throttle lever to FAST position.

SHUTTING DOWN

To stop the engine at any time, move the On/O mechanism to

the OFF or STOP position.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Comments to this Manuals

No comments

Earthquake 6015V User Manual Page 14

Comments to this Manuals

Related products and manuals for Special machinery Earthquake 6015V