Earthquake 6015V User Manual download pdf (Page 15)

15Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5

Operator’s Manual

6015 Series CRT Rototiller

WARNING

TEMPERATURE OF MUFFLER AND NEARBY AREAS MAY

EXCEED 150° F. AVOID THESE AREAS.

DO NOT MOVE CHOKE CONTROL TO CHOKE TO STOP

ENGINE. BACKFIRE OR ENGINE DAMAGE MAY OCCUR.

TO STOP WHEELS AND TINES AT ANY TIME, RELEASE

DRIVE SAFETY CONTROL LEVERS TO NEUTRAL POSI

TION.

ALWAYS RELEASE DRIVE SAFETY CONTROL LEVERS TO

NEUTRAL POSITION BEFORE ADJUSTING THE DEPTH

OF THE REGULATOR LEVER.

DANGER

ENGINE AND SURROUNDING PARTS BECOME

EXTREMELY HOT DURING NORMAL USE AND WILL

CAUSE SERIOUS BURN INJURIES IF TOUCHED BEFORE

THE ENGINE HAS COOLED.

ALLOW ENGINE TO COOL COMPLETELY BEFORE

TOUCHING THESE HOT SURFACES.

IMPORTANT

PRACTICE OPERATING THE CONTROLS AND TILLER

WITH TINES OUT OF GROUND BEFORE BEGINNING

TO TILL. IT IS IMPORTANT THAT YOU KNOW HOW TO

USE THE TILLER PROPERLY, KEEP CONTROL AT ALL

TIMES, STOP THE TINES AND WHEELS FROM TURNING,

AND STOP THE ENGINE IF NECESSARY. IF YOU DO

NOT KNOW HOW TO DO THESE THINGS, READ THE

CONTROLS, ADJUSTMENTS AND SAFETY SECTIONS

BEFORE PROCEEDING.

DRIVE SAFETY CONTROL LEVER

Pull the drive safety control lever toward the handlebar to the

FORWARD position to engage the wheels and tines. Releasing

the lever into the NEUTRAL position stops the wheels and tines

and brings the tiller to a complete stop. SEE FIGURE 5

TILLING

1. Adjust the depth regulator lever to desired tilling depth.

NOTE: Raise depth regulator lever up one hole at a time,

testing tiller operation after each raise. Raising depth

regulator lever too high can result in loss of control of tiller!

2. Move the throttle control to FAST position.

3. Place the tiller in FORWARD by pulling the drive safety control

lever toward the handlebar, this will engage the wheels and

tines.

SHUTTING DOWN

To stop the engine at any time, move the On/O mechanism

to the OFF or STOP position. To stop wheels and tines at any

time release drive safety control levers to NEUTRAL position.

SEE FIGURE 5

lever engaged (FORWARD)

FIGURE 5

drive safety control lever

disengaged (NEUTRAL)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Comments to this Manuals

No comments

Earthquake 6015V User Manual Page 15

Comments to this Manuals

Related products and manuals for Special machinery Earthquake 6015V